Injection molding operation requirements

 

First, the quality requirements of plastic products

1. After injection molding, the product structure must be guaranteed to be complete, and there should be no shortage of materials or materials.

2. The surface of the product is bright in color, uniform in color, and full.

3. The surface of the product is not filled with defects such as flowers, impurities and black spots.

4, The shape of the product is regular, with no deformation, distortion, and obvious bubbles inside the product.

  5,The product can be matched with the relevant parts and normal, can not be separated without external force.

6. For products that need to be assembled, after assembly, the operator needs to perform a self-test to ensure that the product meets the quality requirements. Not allowed

Not installed, missing, and broken.

Second, plastic products trimming requirements

1. The feeding port of the product is generally cut off with a trimming knife, and the cutting position cannot be clearly whitish.

2. When trimming the knife, when trimming the product, the force should be repaired from the inside out when repairing the product. The direction of the force is not allowed to be blocked by the other hand.

3. When the product is trimmed, the force on the shank should be even, ensure that the force can cut off the product as much as possible, the long front of the batch, the middle does not stagnate, once repaired to the end, to ensure the finished the appearance of the edge after trimming

 4. The surface of the product that has been trimmed is not allowed to have wavy lines and unevenness.

5. For the part where the inlet is removed, the trimming should be smooth, and slight scratches caused by improper trimming in the range of φ10 are allowed. Other parts are not allowed to have scratches due to improper trimming.

6. For the height of the draping height greater than 0.2mm, it should be trimmed (unless the adjustment of the injection parameters can be solved), especially the flank on the edge of the outline of the product must be removed.

7. For different products, it is recommended to use different types of trimming knives to ensure product quality and improve trimming efficiency.

8. It is not allowed to damage other qualified surfaces due to improper trimming operation (such as causing good surface scratches, cuts, etc.).

 

Third, product stacking and handling

1. The height of the product stacked on the pallet should not exceed 1.2mm. The number of products in the same specification must be the same. Finally, it is bundled with a winding die. For small products placed in the tote, the height of the product should be 10CM at the tote, and the loading weight of the tote should not exceed 25Kg.